Maxima V6-3.5L (VQ35DE) (2007)
/Page-1887004.png)
-
Use a fender cover or large floor-mat. Place it with the seat back lying flat so you can reach the underside of the seat.
Figure 3
10. Remove the four seat bottom cushion bolts-M8, 12 mm head (see Figure 3).
-
Removing these bolts will release the cushion from the frame.
11. Remove the two seat track mounting tab bolts (M6, 10 mm head), one on each side. They re near the cushion bolts you just removed (see Figure
3).
-
Removing these bolts will release the seat slide rails from the "worm gears".
Figure 4
12. Remove the top screw only from the RH & LH side finishers (see Figure 4).
13. Remove both screws and finisher from the front edge of the seat (see Figure 4).
Figure 5
14. Disconnect the seat sub-harness connector from the slide motor (see Figure 5).
15. Remove two bolts, one from each side of the seat frame-M8, 12 mm head (see "Remove this bolt first" in Figure 5).
