Maxima V6-3.5L (VQ35DE) (2007)
/Page-1243002.png)
2. Remove the sensor rotor from the drive shaft using a suitable tool as shown.
Rear
The rear wheel sensor rotor is built into the rear wheel hub. For removal and installation procedure, refer to RAX-6, "Removal and Installation". See:
Steering and Suspension/Suspension/Testing and Inspection
INSTALLATION
Front
Installation is in the reverse order of removal.
^
Install the sensor rotor using a wooden block and suitable tool as shown.
^
Always replace sensor rotor with new one.
Rear
The rear wheel sensor rotor is built into the rear wheel hub. For removal and installation procedure, refer to RAX-6, "Removal and Installation". See:
Steering and Suspension/Suspension/Testing and Inspection
