nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Ignition Relay > < Ignition Control Module|Testing and Inspection
Page 2
background image

15. Fix ignition coil using a rope etc. with gap of 13 - 17 mm between the edge of the spark plug and grounded metal portion as shown in the figure.
16. Crank engine for about 3 seconds, and check whether spark is generated between the spark plug and the grounded metal portion.

Spark should be generated.

CAUTION:
-

Do not approach to the spark plug and the ignition coil within 50 cm. Be careful not to get an electrical shock while checking, because
the electrical discharge voltage becomes 20 kV or more.

-

It might cause to damage the ignition coil if the gap of more than 17 mm is taken.

NOTE:  When the gap is less than 13 mm, the spark might be generated even if the coil is malfunctioning.

17. If NG, replace ignition coil with power transistor.

Ignition Relay > < Ignition Control Module|Testing and Inspection