Maxima V6-3.5L (VQ35DE) (2007)
Impact Sensor: Service and Repair
Side Air Bag (Satellite) Sensor
SIDE AIR BAG (SATELLITE) SENSOR
Removal and Installation
CAUTION:
-
Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
-
Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
-
Do not disassemble side air bag (satellite) sensor.
-
Do not use old nuts after removal; replace with new nuts.
-
Check side air bag (satellite) sensor to make sure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it
with new one.
REMOVAL
1. Disconnect negative and positive battery cables, then wait at least 3 minutes.
2. Remove seat belt pre-tensioner.
3. Remove side air bag (satellite) sensor nuts.
4. Disconnect side air bag (satellite) sensor harness connector.
INSTALLATION
Installation is in the reverse order of removal.
-
After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRS-21, "SRS Operation Check". See:
Testing and Inspection/Component Tests and General Diagnostics