Maxima V6-3.5L (VQ35DE) (2007)
Inspection With Consult-II (Self-Diagnosis)
CAN Diag Support MNTR
CAN DIAG SUPPORT MNTR
Refer to "SYSTEM DESCRIPTION" in Information Bus.
Auto Active Test
Auto Active Test
DESCRIPTION
-
In auto active test mode, operation inspection can be performed when IPDM E/R sends a drive signal to the following systems:
-
Rear window defogger
-
Front wipers
-
Tail, license plate, and parking lamps
-
Cornering lamps
-
Front fog lamps
-
Headlamps (High, Low)
-
A/C compressor (magnet clutch)
-
Cooling fan
OPERATION PROCEDURE
1. Close hood and front door RH, and lift wiper arms away from windshield (to prevent glass damage by wiper operation).
NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand.
2. Turn ignition switch OFF.
3. Turn ignition switch ON and, within 20 seconds, press front door switch LH 10 times. Then turn ignition switch OFF.
4. Turn ignition switch ON within 10 seconds after ignition switch OFF.
5. When auto active test mode is actuated, horn chirps once.
6. After a series of operations is repeated three times, auto active test is completed.
NOTE: When auto active test mode has to be cancelled halfway, turn ignition switch OFF.
CAUTION: Be sure to perform BL-29, "Door Switch Check" when the auto active test cannot be performed. See: Body and Frame/Locks/Power
Locks/Testing and Inspection/Component Tests and General Diagnostics/Door Switch Check