Maxima V6-3.5L (VQ35DE) (2007)
Axle Shaft Assembly: Removal and Replacement
FRONT DRIVE SHAFT
Removal and Installation
Exploded View FAX-11
CAUTION:
^
Circular clips should be properly meshed with the differential side gear (transaxle side). Check that the circular clips are properly seated
after installation and that the drive shaft will not come out. Always use a new circular clip for installation.
^
Use a suitable cloth or protector over the boots to prevent damage to the boots during removal and installation.
REMOVAL
1. Remove the wheel and tire.
2. Remove brake caliper assembly and disc rotor.
CAUTION:
^
Do not twist or stretch the brake hose when removing components.
^
Discard the cotter pin and use a new cotter pin for installation.
NOTE: The brake caliper does not need to be disconnected.
3. Remove the cotter pin, and the wheel bearing lock nut using power tool.
4. Remove the underbody splash shield.
5. Remove the lower ball joint cotter pin and nut using power tool.
CAUTION: Discard the cotter pin and use a new cotter pin for installation.