Maxima V6-3.5L (VQ35DE) (2007)
Thoroughly clean all parts in cleaning solvent, and dry with compressed air. Check parts for evidence of deformation or other damage. Replace as
necessary.
Shaft
Replace drive shaft if it is twisted or cracked.
Joint Assembly (Transaxle Side)
^
Check serration for deformation. Replace if necessary.
^
Check slide joint housing and spider assembly for any damage. Replace if necessary.
CAUTION: The slide joint housing and spider assembly must be replaced as a set, even if only one component is damaged then both must
be replaced.
Joint Assembly (Wheel Side)
Replace joint assembly if it is deformed or damaged.
Housing (Slide Joint)
^
Check for damage or abnormal wear on ball rolling surface.
^
Check for wear on shaft bolts.
^
Check for deformity on boot install part.
Support Bearing
Make sure wheel bearing rolls freely and is free from noise, cracks, pitting or wear.
ASSEMBLY
CAUTION:
^
After drive shaft has been assembled, ensure that it moves smoothly over its entire range without binding.
^
Use Genuine NISSAN Grease or equivalent after every overhaul.
Transaxle Side
1. Install boot and new small boot band on drive shaft.
CAUTION: Cover drive shaft serration with tape so as not to damage boot during installation.
2. Install the spider assembly securely, making sure the marks which were made during disassembly are properly aligned.
3. Install a new snap ring using a suitable tool.
4. Pack the drive shaft joint with the specified amount of grease (Genuine NISSAN Grease or equivalent).
5. Install the slide joint housing.