Maxima GLE V6-3.5L (VQ35) (2002)
/Page-2108001.png)
Impact Sensor: Service and Repair
Crash Zone Sensor
REMOVAL AND INSTALLATION
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect the battery ground cable and wait at least 3 minutes.
-
Do not use old bolts coated with bonding agent after removal; replace with new ones.
-
Check crash zone sensor for proper installation.
-
Check crash zone sensor to ensure they are free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with new
one.
-
After replacement of crash zone sensor, check SRS function and perform self-diagnosis for SRS. Refer to "SRS Operation Check" for details.
-
Do not attempt to disassemble crash zone sensor.
-
Replace crash zone sensor if it has been dropped or sustained an impact.
1. Disconnect crash zone connector.
2. Remove ground bolt and remove nuts from crash zone sensor. Then remove the crash zone sensor from bracket.
NOTE: To install, reverse the removal procedure sequence.
Satellite Sensor
REMOVAL AND INSTALLATION
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect the battery ground cable and wait at least 3 minutes.
-
Do not use old bolts coated with bonding agent after removal; replace with new ones. .
-
Check satellite sensor for proper installation.
-
Check satellite sensor to ensure they are free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with new one.
-
After replacement of satellite sensor, check SRS function and perform self-diagnosis for SRS. Refer to "SRS Operation Check" for details.
-
Do not attempt to disassemble satellite sensor.
-
Replace satellite sensor if it has been dropped or sustained an impact.
1. Remove seat belt pre-tensioner. Refer to "Front Seat Belt" for details.
2. Disconnect satellite sensor connector.
3. Remove bolt and nuts from satellite sensor unit.
Then remove the satellite sensor.
NOTE: To install, reverse the removal procedure sequence.
