Maxima GLE V6-3.5L (VQ35) (2002)
/Page-1880002.png)
-
Initially, tighten nut on tie-rod outer socket and knuckle arm to 29 to 39 Nm (3 to 4 kg-m, 22 to 29 ft. lbs.). Then tighten further to align nut
groove with first pin hole so that cotter pin can be installed.
CAUTION: Tightening torque must not exceed 49 Nm (5 kg-m, 36 ft. lbs.).
-
Before removing lower joint from gear, set gear in neutral (wheels in straight-ahead position). After removing lower joint, put matching mark
on pinion shaft and pinion housing to record neutral position.
-
To install, set left and right dust boots to equal deflection. Attach lower joint by aligning matching marks of pinion shaft and pinion housing.
-
Tighten gear housing mounting bracket bolts in the order shown.
