nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 5430 > < Diagram Information and Instructions|Page 5428
Page 1
background image

Body Control Module: Description and Operation

OUTLINE

The In-Vehicle Multiplexing System, IVMS (LAN system), See: Information Bus consists of a BCM (Body Control Module) and five LCUs (Local
Control Units)
. Some switches and electrical loads are connected to each LCU. Some electrical systems are directly connected to the BCM. Control of
each LCU, (which is provided by a switch and electrical load), is accomplished by the BCM, via multiplex data lines (A-1, A-2) connected between
them.

BCM (Body Control Module)

The BCM, which is a master unit of the IVMS (LAN), consists of microprocessor, memory and communication LSI sections and has communication and
control functions. It receives data signals from the LCUs and sends electrical load data signals to them.

LCU (Local Control Unit)

The LCUs, which are slave units of the BCM, have only a communication function and consist of communication LSI and input-output interface circuits.
They receive data signals from the BCM, control the ON/OFF operations of electrical loads and the sleep operation, as well as send switch signals to the
BCM.

CONTROLLED SYSTEMS

The IVMS controls several body-electrical systems. The systems included in the IVMS are as follows:

-

Power window

-

Power door lock

-

Multi-remote control system

-

Theft warning system

-

Interior lamp (ON-OFF Control)

-

Step lamp

-

Illumination (Power window switch illumination)

-

Ignition key warning. (Refer to "Warning Buzzer")

-

Light warning. (Refer to "Warning Buzzer")  

-

Seat belt warning. (Refer to "Warning Buzzer") 

-

Wiper amp. (Refer to "Wiper and Washer")  

-

Rear window defogger timer. (Refer to "Rear Window Defogger")  

-

Power window (Refer to "Power Window - IVMS)

-

Trouble-diagnosing system

Also, IVMS has the "sleep/wake-up control" function. IVMS puts itself (the whole IVMS system) to sleep under certain conditions to prevent
unnecessary power consumption. Then, when a certain input is detected, the system wakes itself up. For more detailed information, refer to
"Sleep/Wake-up Control".

Diagram Information and Instructions|Page 5430 > < Diagram Information and Instructions|Page 5428