Maxima SE V6-3.0L (VQ30DE) (1998)
Manifold Pressure/Vacuum Sensor: Component Tests and General Diagnostics
COMPONENT INSPECTION
MAP/BARO switch solenoid valve
With CONSULT
1. Start engine and warm it up to normal operating temperature.
2. Perform "MAP/BARO SW/V" in "ACTIVE TEST" mode with CONSULT.
3. Check the following.
-
Condition: At idle under no-load
-
CONSULT display
4. If NG, check solenoid valve as shown below.
- - - OR - - -
Without TOOLS
1. Turn ignition switch "OFF" and remove MAP/BARO switch solenoid valve.
2. Check air passage continuity.
3. Check the time required for the solenoid valve to switch. It should be less than 1 second.