Maxima SE V6-3.0L (VQ30DE) (1998)
3. Separate tie-rod from knuckle with Tool. Install stud nut on stud bolt to prevent damage to stud bolt.
4. Separate drive shaft from knuckle by lightly tapping it. If it hard to remove, use a puller. Cover boots with shop towel so as not to damage them
when removing drive shaft.
5. Remove strut lower mounting bolts.
6. Loosen lower ball joint tightening nut.
7. Separate knuckle from lower ball joint stud with Tool.
8. Remove knuckle from transverse link.
INSTALLATION
1. Install knuckle with wheel hub.