nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Component Testing Procedures|Page 11536 > < Component Testing Procedures|Page 11534
Page 6
background image

(4) Accelerate vehicle to more than 70 km/h (43 MPH) and maintain the following condition continuously until "TESTING" has turned to

"COMPLETED". (It will take approximately 30 seconds after "TESTING" shows.)
THROTTLE POSI: 1/8 - 2/8 (at all times during step 4) 
Selector lever: D position (OD "ON") 
TCC S/V DUTY: More than 94%
VHCL/S SE.A/T Constant speed of more than 70 km/h (43 MPH)
-

Check that "GEAR" shows "4".

-

If "TESTING" does not appear on CONSULT for a long time, select "SELF-DIAG RESULTS". In case a 1st trip DTC other than P0744 is
shown, refer to applicable "TROUBLE DIAGNOSIS FOR DTC".

(5) Make sure that "OK" is displayed. (If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE".)

Refer to "DIAGNOSTIC PROCEDURE".

Component Testing Procedures|Page 11536 > < Component Testing Procedures|Page 11534