Maxima SE V6-3.5L (VQ35) (2002)
Part 2
Removal and Installation
CAUTION: When removing or installing body side welts, do not allow butyl seal to come in contact with pillar garnish and headlining.
1. Remove rear seats. Refer to "REAR SEAT" for details.
2. Remove shoulder anchor bolts. Refer to "Front Seat Belt" for details.
3. Remove front pillar garnishes, center pillar upper garnishes and rear pillar garnishes. Refer to "SIDE AND FLOOR TRIM" for details.
4. Remove steering wheel. Refer to "Driver Air Bag Module and Spiral Cable" for details.
5. Push back the front seat back.
6. Remove two screws from the roof console of map lamp, and insert a removal tool wrapped in clean cloth between the right-hand side of the map
lamp and headlining, then remove the roof console and disconnect connectors.[A]
7. Remove sun visors.
8. Remove assist grips.[B]
9. Remove interior lamp assembly, then disconnect connectors.[C]