Maxima SE V6-3.5L (VQ35) (2002)
21
Tighten the six base plate nuts (three on each side) located at the top of the seat frame, to secure the gear boxes. Nut torque: 64-85 in-lb (7.17-9.69
Nm).
22.
Re-install and tighten two M8 (12 mm head) bolts located to the sides of the front edge of the seat (see figure 6) Bolt torque: 13-17 ft-lb (17.5-23.7
Nm).
23.
Check the gear case to mounting tab distance again. Make sure they have not moved (see figure 11). If N/G, adjust.
24.
Tighten M6 (10 mm head) bolt into both seat track mounting tabs. Bolt torque: 65-84 in lb (7.3-9.4 Nm).
25.
Re-install screws to attach the side finishers (refer to figure 5, if needed).
26.
Re-install four M8 (12 mm head) bolts to tighten the seat bottom cushion to the seat frame (refer to figure 4, if needed). Bolt torque: 13-17 ft-lb
(17.5-23.7 Nm).
27.
Re-connect slide motor connector, making sure it snaps in place.
28.
Re-hook strap to attach the carpet flap onto the bottom of the seat (refer to figure 3, if needed).
29.
Place the seat assembly back into the vehicle and re-connect all electrical connectors. Make sure they all snap together securely.
30.
Re-connect the battery negative cable.
31.
Re-install four seat mounting bolts. Bolt torque: 27-36 ft-lb (37-49 Nm).
32.
Operate the seat switches to ensure normal operation has returned.
33.
For the ADP entry/exit feature (if equipped) to return to normal operation, procedure A or B must be performed.
Procedure A:
a.
Insert key into the ignition key cylinder. (Ignition switch is in "OFF" position.)
b.
Open - close - open the driver side door. (Do not perform with the door switch operation.)
C.
End
Procedure B:
a.
Drive the vehicle at more than 25 km/h (16 MPH).
b.
End
34.
Re-program the radio presets.
35.
Re-set the clock.