Maxima SE V6-3.5L (VQ35) (2002)
13.
Remove the top screw only from the RH & LH side finishers (see figure 5).
^
If equipped, remove both screws and finisher from the front edge of the seat (see figure 5).
14.
Disconnect the seat sub-harness connector (to slide motor - see figure 6).
^
Remove M8 (12 mm head) bolt from both sides of the seat frame, located to the sides of the front edge of seat (see figure 6).
^
Then, remove six nuts and two base plates on both sides, located at the top of the seat frame, to release the gear boxes (see figure 6).