Maxima SE V6-3.5L (VQ35) (2002)
SETTING UP:
1.
Install the Reprogramming Card into CONSULT-II.
^
The Reprogramming Software Card is the "orange" Card.
^
Use slot A-top slot (see Figure 1).
2.
Connect the AC power supply to CONSULT-II.
3.
Connect CONSULT-II to the ASIST PC with the special Ethernet cable (P/N 02002554 is printed on the cable).
A.
Connect one end to CONSULT-II at the "PC port".
B.
Connect the other end to the ASIST PC at the "Ethernet card" connection port.
4.
Confirm the CONSULT-II date and time are correctly set as follows:
(This is necessary to provide a valid print-out for warranty claims.)
A.
With the Reprogramming card in slot A, turn "ON" CONSULT-II.
B.
Touch [SUB MODE].
C.
Touch [SET DATE] (see Figure 2).
1)
If the date is not correct, touch the [MONTH], [DAY] or [YEAR] as needed. Then adjust it by using arrow keys. Once done, press
[SAVE], press [BACK], and go to step D.
2)
If the date is OK, press [BACK] and go to step D.