Maxima SE V6-3.5L (VQ35) (2002)
Diagnosis Sensor Unit: Service and Repair
DIAGNOSIS SENSOR UNIT
REMOVAL AND INSTALLATION
CAUTION:
-
Before servicing SRS, turn the ignition switch off, disconnect the battery ground cable and wait at least 3 minutes.
-
Do not use old bolts after removal; replace with new ones.
-
Check diagnosis sensor unit for proper installation.
-
Check diagnosis sensor unit to ensure it is free of deformities, dents, cracks or rust. If they show any visible signs of damage, replace them with
new ones.
-
Check diagnosis sensor unit brackets to ensure they are free of deformities or rust.
-
Replace diagnosis sensor unit if it has been dropped or sustained an impact.
-
After replacement of diagnosis sensor unit, perform self-diagnosis for SRS. Refer to "SRS Operation Check" for details.
1. Disconnect driver, passenger and side air bag module connectors. Also, disconnect seat belt pre-tensioner connector.
2. Remove console box. Refer to " INSTRUMENT PANEL ASSEMBLY".
3. Disconnect diagnosis sensor unit connector.
4. Remove ground bolt and also remove bolts from diagnosis sensor unit. Then remove the diagnosis sensor unit.
NOTE: To install, reverse the removal procedure sequence.