Maxima SE V6-3.5L (VQ35) (2002)
-
Remove connector and flow control valve with spring.
Be careful not to drop flow control valve.
Do not disassemble flow control valve.
Inspection
-
If pulley is cracked or deformed, replace it.
-
If an oil leak is found around pulley shaft oil seal, replace the seal.
-
If serration on pulley or pulley shaft is deformed or worn, replace it.
Assembly
Assemble oil pump, noting the following instructions.
-
Make sure O-rings and oil seal are properly installed.
-
Always install new O-rings and oil seal.
-
Be careful of oil seal direction.
-
Cam ring, rotor and vanes must be replaced as a set if necessary.
-
Coat each part with Genuine Nissan PSF II or equivalent when assembling.
-
Pay attention to the direction of rotor.