Maxima SE 20th V6-3.0L (VQ30DE) (2001)
1.
Press [SUB MODE] (see Figure 4) then:
a.
From the listed items, find and select [BATTERY CHARGE].
2.
Check the CONSULT-II's "Charger Input" reading (see Figure 5).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
Charger Input" is the voltage level of the vehicle's battery. (It must be above 12 volts.)
^
The general procedure includes a list of items to check when "Charger Input" voltage is below 12V.
Step Three: Reprogram the Vehicle ECM
Step Four: "Wrap-up" After Reprogramming is Finished
1.
Turn the ignition switch "OFF" and turn CONSULT-II "OFF".
2.
Wait more than 10 seconds, then;
a.
Turn the ignition switch "ON" for 2 second, then