Maxima Wagon V6-2960cc 3.0L SOHC MFI (VG30E) (1986)
Parking Brake Cable: Technical Service Bulletins
Brakes - Parking Brake Cable Installation Caution
Models
1985-1987 Maxima
Section
Brakes
Classification
BR86-002
Bulletin No.
TS86-163
Date
September 17, 1986
PARKING BRAKE CABLE INSTALLATION CAUTION, 1985-1987 MAXIMA
APPLIED MODEL: 1985-1987 Maxima
SERVICE INFORMATION
Use the following procedure to attach the parking brake cables to the cable guides on 1985-1987 Maxima vehicles. This procedure applies to the cable
guides at the rear calipers on 1985-1987 models, and also to the underbody mounts at the front end of the cables on 1985-1986 models.
1.
Pull back the rubber boots to expose the cable. This will allow the cable to be installed without damage to the boot.
2.
Slide the bare cable through the slot in the cable guide.
3.
Install the cable lock plate on the cable cover fitting to secure the cable.
4.
Attach the rubber boot to the fitting.
CAUTION: It is important not to damage the boot because it prevents water from entering the cable. Water in the cable may freeze during the winter or
cause corrosion.