Murano AWD V6-3.5L (VQ35) (2003)
/Page-2315018.png)
b.
From inside the vehicle, use one hand to push out the center of the window.
^
If tick or pop noise is heard, this bulletin does not apply; see NTB03-105.
3.
To further confirm this bulletin applies.
a.
Remove the door finisher (panel) from the side that is making noise.
b.
Drive the vehicle over rough and uneven road surfaces.
^
If the incident noise is eliminated (gone) with the door panel removed, continue with this bulletin.
^
If the incident noise is still heard, this bulletin does not apply. See steps 1 and 2 above.
SERVICE NOTES BEFORE STARTING:
A.
You will be performing various repairs to the door finisher (panel).
^
This will include applying cloth and foam strips and re-gluing a foam block.
^
See all the locations shown in Figure 2.
B.
These repairs require removal of the door panel.
^
See section EI in the Service Manual (ESM) for door panel removal instructions.
^
Place the door panel on a clean protective surface.
