Murano AWD V6-3.5L (VQ35) (2003)
5. While holding the door window, raise it at the rear end to pull the glass out of the sash toward the outside of the door.
6. Remove the mounting bolts, and remove the module assembly.
7. Disconnect the harness connector for the module assembly, and uncap the harness from the back.
INSTALLATION
Install in the reverse order of removal.
INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction
is detected, replace or grease it.
-
Wire wear
-
Regulator deformation
-
Grease condition for each sliding part
The arrows in the figure show the application points of the body grease.