Murano AWD V6-3.5L (VQ35) (2003)
1. Apply a rubber grease to new piston seal and insert seal into groove on cylinder body.
CAUTION: Do not reuse the piston seals.
2. Apply brake fluid or rubber grease to the piston boot, place it on the piston, and insert the piston boot cylinder-side lip into the cylinder body
groove.
CAUTION: Do not reuse the piston boot.
3. Insert the piston boot piston-side lip into the piston groove.
CAUTION: Press the piston evenly and vary the pressing point to prevent cylinder inner wall from being rubbed.
4. Fix piston boot with retaining ring.
CAUTION:
-
Make sure the boot is firmly in the cylinder body groove.
-
Do not reuse the retaining ring.
5. Install the sliding pin bolt and sliding pin boot to the torque member.
6. Apply PBC (Poly Butyl Cuprysil) grease or silicon-based grease to the rear of the pad and to both sides of the shim, and attach the inner shim and
shim cover to the inner pad, and the outer shim and outer shim cover to the outer pad.