nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

CAN System (Type 1)|Page 6786 > < CAN System (Type 1)|Page 6784
Page 24
background image

1. When there are no indications of "TRANSMISSION", "AIR PRESSURE MONITOR" or "METER A/C AMP" on "SELECT SYSTEM" display

of CONSULT-II, print the "SELECT SYSTEM".

2. Print all the data of "SELF-DIAG RESULTS" for "ENGINE", "TRANSMISSION", "AIR PRESSURE MONITOR", "BCM", "METER A/C

AMP", and "ABS" displayed on CONSULT-II.

3. Print all the data of "DATA MONITOR (CAN DIAG SUPPORT MNTR)" for "ENGINE", "TRANSMISSION", "AIR PRESSURE MONITOR",

"BCM", "METER A/C AMP", and "ABS" displayed on CONSULT-II.

4. Attach the printed sheet of "SELECT SYSTEM", "SELF-DIAG RESULTS" and "DATA MONITOR (CAN DIAG SUPPORT MNTR)" onto the

check sheet. Refer to "CHECK SHEET".

5. Based on the indications of "SELECT SYSTEM" and the results of "DATA MONITOR (CAN DIAG SUPPORT MNTR)", put marks "v" onto

the items with "No indication", "NG", or "UNKWN" in the check sheet table. Refer to "CHECK SHEET".

NOTE:
-

If "NG" is displayed on "CAN COMM" as "DATA MONITOR (CAN DIAG SUPPORT MNTR)" for the diagnosed control unit, replace the
control unit.

-

The "DATA MONITOR (CAN DIAG SUPPORT MNTR)" items, which are not in check sheet table, are not related to diagnostic procedure.
So it is not necessary to check the status of "DATA MONITOR (CAN DIAG SUPPORT MNTR)" items which are not indicated in check
sheet table.

6. Check CAN communication line of the integrated display system. Refer to "CAN Communication Line Check". See: Accessories and Optional

Equipment/Driver/Vehicle Information Display/Testing and Inspection/Symptom Related Diagnostic Procedures/Non-Trouble Code Diagnostic
Procedures/AV Communication Line Check

7. Attach the CAN DIAG MONITOR check sheet onto the check sheet. Refer to "CHECK SHEET".
8. Mark the "NG" or "UNKWN" item of the check sheet table with "v" from the result of CAN DIAG MONITOR check sheet. Refer to "CHECK

SHEET".

NOTE:  If "NG" is displayed on "CAN COMM" as "CAN DIAG MNTR" for the diagnosed control unit, replace the control unit. Refer to "CAN
Communication Line Check". See: Accessories and Optional Equipment/Driver/Vehicle Information Display/Testing and Inspection/Symptom
Related Diagnostic Procedures/Non-Trouble Code Diagnostic Procedures/AV Communication Line Check

CAN System (Type 1)|Page 6786 > < CAN System (Type 1)|Page 6784