Murano AWD V6-3.5L (VQ35) (2003)
/Page-1072924.png)
3. Print all the data of "DATA MONITOR (CAN DIAG SUPPORT MNTR)" for "ENGINE", "TRANSMISSION", "AIR PRESSURE MONITOR",
"BCM", "METER A/C AMP", "AUTO DRIVE POS.", "ALL MODE 4WD" "ABS" displayed on CONSULT-II.
4. Attach the printed sheet of "SELECT SYSTEM", "SELF-DIAG RESULTS" and "DATA MONITOR (CAN DIAG SUPPORT MNTR)" onto the
check sheet. Refer to "CHECK SHEET".
5. Based on the indications of "SELECT SYSTEM" and the results of "DATA MONITOR (CAN DIAG SUPPORT MNTR)", put marks "v" onto
the items with "No indication", "NG", or "UNKWN" in the check sheet table. Refer to "CHECK SHEET".
NOTE:
-
If "NG" is displayed on "CAN COMM" as "DATA MONITOR (CAN DIAG SUPPORT MNTR)" for the diagnosed control unit, replace the
control unit.
-
The "DATA MONITOR (CAN DIAG SUPPORT MNTR)" items, which are not in check sheet table, are not related to diagnostic procedure.
So it is not necessary to check the status of "DATA MONITOR (CAN DIAG SUPPORT MNTR)" items which are not indicated in check
sheet table.
6. Check CAN communication line of the navigation system. Refer to "CAN Communication Line Check". See: Accessories and Optional
Equipment/Navigation System/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Non-Trouble Code Procedures/CAN
Communication Line Check
7. Attach the CAN DIAG SUPPORT MONITOR check sheet onto the check sheet. Refer to "CHECK SHEET".
8. Mark the "NG" or "UNKWN" item of the check sheet table with "v" from the result of CAN DIAG SUPPORT MONITOR check sheet. Refer to
"CHECK SHEET".
NOTE: If "NG" is displayed on "CAN COMM" as "CAN DIAG SUPPORT MONITOR" for the diagnosed control unit, replace the control unit.
Refer to "CAN Communication Line Check". See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/Non-Trouble Code Procedures/CAN Communication Line Check
9. According to the check sheet results (example), start inspection. Refer to "CHECK SHEET RESULTS (EXAMPLE)".
