Murano AWD V6-3.5L (VQ35) (2003)
3.
Start the engine and check the idle speed.
^
If idle speed is too low, perform IAVL (Idle Air Volume Learning). See the appropriate Service Manual (ESM) for this procedure.
NOTE:
If the engine will not idle, hold the engine RPM at about 2000, then slowly bring it down to an idle. IAVL can now be performed.
4.
Confirm the engine is operating normally.
5.
Make sure the "Check Engine Light" (MIL) is not "ON".
^
If necessary, use CONSULT-II and the Diagnostic (red/white) Card to erase any DTC's that may have stored during the reprogramming
procedure.