nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

ABOUT US
Variable Valve Timing Actuator Position Sensor > < Diagram Information and Instructions|Page 4891

Murano AWD V6-3.5L (VQ35) (2003)

Page 1
background image

Throttle Position Sensor: Testing and Inspection

THROTTLE POSITION SENSOR

1. Reconnect all harness connectors disconnected.
2. Perform "Throttle Valve Closed Position Learning".
3. Turn ignition switch "ON".
4. Set selector lever to "D" position. 

5. Check voltage between ECM terminals 50 (TP sensor 1signal), 69 (TP sensor 2signal) and engine ground under the following conditions.
6. If NG, replace electric throttle control actuator and go to the next step.
7. Perform "Throttle Valve Closed Position Learning".
8. Perform "Idle Air Volume Learning".

Variable Valve Timing Actuator Position Sensor > < Diagram Information and Instructions|Page 4891