Murano AWD V6-3.5L (VQ35) (2003)
Fluid - Transfer Case: Service and Repair
Changing Transfer Fluid
Replacement
DRAINING
CAUTION: When draining oil, protect exhaust tube flange with cover.
1. Run the vehicle to warm up the transfer body sufficiently.
2. Stop the engine, and remove the drain plug to drain the transfer oil.
3. Apply recommended sealant to drain plug. Position drain plug on transfer and tighten to the specified torque.
Drain plug tightening torque: 9.8 - 19.6 Nm (1.0 - 1.9 kg-m, 87 - 173 inch lbs.)
FILLING
1. Remove filler plug and add gear oil until oil level reaches the specified limit near filler plug mounting hole.
Oil capacity: Approximately 0.31 L (5/8 US pt. 1/2 Imp pt)
CAUTION: Carefully fill the oil. (Fill up for approximately 3 minutes)
2. Leave the vehicle for 3 minutes, and check the oil level again.
3. Apply recommended sealant to filler plug. Position filler plug on transfer and tighten to the specified torque.
Drain plug tightening torque: 9.8 - 19.6 Nm (1.0 - 1.9 kg-m, 87 - 173 inch lbs.)