Murano FWD V6-3.5L (VQ35) (2004)
d. Apply a continuous bead of sealant to the cylinder block mating surface of the upper oil pan to a limited portion as shown.
Use Genuine RTV Silicone Sealant or equivalent.
CAUTION:
^
For bolt holes with * marks (5 locations), apply liquid gasket outside the holes.
^
Apply a bead of 4.5 to 5.5 mm (0.177 to 0.217 inch) diameter to area "A".
^
Attaching should be done within 5 minutes after coating.
e. Install the upper oil pan.
^
Tighten bolts in numerical order as shown.
^
There are two types of mounting bolts. Refer to the following for locating bolts.
M8 x 100 mm (3.97 inch) : 5, 7, 8,11
M8 x 25 mm (0.98 inch) : Except the above
f.
Install the four engine-to-transaxle bolts. (2WD models)
g. Install oil strainer to oil pump.
2. Install the lower oil pan in the order.
a. Use a scraper to remove old liquid gasket from mating surfaces.
^
Also remove old liquid gasket from mating surface of upper oil pan.