Murano FWD V6-3.5L (VQ35) (2004)
/Page-615003.png)
16. Remove the RH and LH intake valve timing control covers.
^
Loosen bolts in reverse order as shown.
^
Use seal cutter [special service tool: KV10111100 037228)] or an equivalent tool to cut liquid gasket for removal.
CAUTION: Shaft is internally jointed with intake camshaft sprocket center hole. When removing, keep it horizontal until it is completely
disconnected.
17. Remove RH engine mounting bracket.
18. Remove front timing chain case.
a. Loosen mounting bolts in reverse order as shown.
b. Insert the appropriate size tool into the notch at the top of the front timing chain case as shown (1).
c. Pry off the case by moving the tool as shown (2).
^
Use seal cutter [special service tool: KV10111100 (J37228)] or an equivalent tool to cut liquid gasket for removal.
CAUTION:
^
Do not use screwdrivers or something similar.
^
After removal, handle it carefully so it does not tilt, cant, or warp under a load.
19. Remove water pump cover and chain tensioner cover from front timing chain case.
^
Use seal cutter [special service tool: KV10111100 (J37228)] or an equivalent tool to cut liquid gasket for removal.
20. Remove the front oil seal from the front timing chain case using a suitable tool.
^
Use screwdriver for removal.
