Murano FWD V6-3.5L (VQ35) (2004)
5. Loosen both wire clamps shown in Figure 2 (clamps on both sides of resonator 1).
6. Replace the wire clamp on air duct B.
a. Pull air duct B away from resonator 1 just enough to remove the old wire clamp and install a new one.
^
Bend the old wire clamp so it cannot be reused.
b. Reconnect air duct B to resonator 1.
CAUTION:
Before installing air duct B, use a clean cloth / rag to wipe away any debris from the duct and resonator.
^ Make sure to align the resonator protrusion with the air duct cut out. Protrusion aligned with cut out.