Murano FWD V6-3.5L (VQ35) (2004)
^ Make sure the slot (cut-out) in the duct is aligned with the largest protrusion on the resonator.
NOTE:
There are 4 protrusions on the resonator, use the largest one to align the air duct.
12. Position and tighten both wire clamps (air duct A and air duct B).
a. Position each wire clamp near the protrusion / cut out (see Figure 6).
b. Tighten the clamps to: 2.2 - 3.0 N-m (0.22 - 0.30 kg-m, 20 - 26 in-lb).
13. Check the wire clamps connecting air duct B with resonators 3 and 4 - make sure they are tight.