Murano FWD V6-3.5L (VQ35) (2004)
Impact Sensor: Service and Repair
Side Air Bag (Satellite Sensor)
SIDE AIR BAG (SATELLITE) SENSOR
Removal and Installation
REMOVAL
CAUTION: Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
1. Remove seat belt pre-tensioner.
2. Remove side air bag (Satellite) sensor fixing nuts.
3. Remove the side air bag (Satellite) sensor connector.
CAUTION:
-
Do not use old nuts; replace with new ones.
-
Check side air bag (Satellite) sensor to ensure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with
new one.
-
Do not disassemble side air bag (Satellite) sensor.
-
Replace side air bag (Satellite) sensor if it has been dropped or sustained an impact.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
-
Check side air bag (Satellite) sensor for proper installation.
-
After replacement of side air bag (Satellite) sensor, perform self-diagnosis to make sure no malfunction is detected. Refer to "SRS Operation
Check".