Murano FWD V6-3.5L (VQ35) (2004)
Windshield Washer Spray Nozzle: Service and Repair
Rear Wiper and Washer System
Removal and Installation of Rear Washer Nozzle
1. Remove high-mounted stop lamp.
2. Remove the rear washer nozzle mounting screw and remove it.
3. Note the following, and install in the reverse order of removal.
-
Tighten rear washer nozzle mounting screw to specified torque.
Rear washer nozzle mounting screw
Tightening Torque : 0.4 Nm (0.04 kg-m, 4 in-lb)
CAUTION:
-
After tightened rear washer nozzle mounting screw, make sure that the rear washer nozzle does not come off when it is pulled downward at 49
N (5 kg, 11 lb) as shown in the figure.
If the washer nozzle come off, replace it together with a new high-mounted stop lamp assembly.
Check Valve
-
A check valve is provided in the washer fluid line. Be careful not to connect check valve to washer tube in the wrong direction.