Pathfinder 2WD V6-3.5L (VQ35) (2003)
Repairs and Inspections Required After a Collision: Service and Repair
Air Bag System
Repairs and Inspections Required After A Collision
Collision Diagnosis
FOR FRONTAL COLLISION
To repair the SRS, perform the following steps.
When SRS (except the side air bag) is activated in a collision:
1. Replace the diagnosis sensor unit.
2. Remove the air bag modules (except the side air bag module) and seat belt pre-tensioner assemblies.
3. Check the SRS components using the table shown:
-
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).
4. Install new air bag modules (except the side air bag module) and seat belt pre-tensioner assemblies.
5. Conduct self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "SRS Operation Check" for details. See: Air Bag
Systems/Testing and Inspection/Component Tests and General DiagnosticsEnsure entire SRS operation properly.
When SRS is not activated in a collision:
1. Check the SRS components using the table shown:
-
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).
2. Conduct self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "SRS Operation Check" for details. See: Air Bag
Systems/Testing and Inspection/Component Tests and General DiagnosticsEnsure entire SRS operation properly.
SRS Inspection (For Frontal Collision) Part 1