Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
2. Insert brake hose end through bracket, then secure it to bracket with lock plate.
3. Install brake tube to brake hose, then tighten flare nut to the specified torque using a suitable tool. Refer to See: Diagrams.
4. Refill brake fluid and bleed air. Refer to See: Brake Bleeding/Service and Repair.
Rear Brake Piping And Brake Hose
BRAKE TUBE AND HOSE
Removal and Installation of Rear Brake Piping and Brake Hose
REMOVAL
1. Drain brake fluid. Refer to See: Brake Fluid/Service and Repair/Removal and Replacement.
2. Remove brake tube from brake hose, using a suitable tool.
3. Remove lock plate and brake hose from bracket.
4. Remove union bolt and copper washers, then remove brake hose from caliper assembly.
CAUTION:
Do not reuse copper washer.
INSTALLATION