Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
Removal
1. Remove the side flange from the final drive assembly. Refer to See: Transmission and Drivetrain/Differential Assembly/Seals and Gaskets/Service
and Repair/Rear Final Drive R200/Side Oil Seal(R200) or (R230).
CAUTION:
Discard side oil seal.
2. Using suitable tool with Tool (puller), remove the sensor rotor from the side flange.
Tool number : ST30031000 ( - )
Installation
1. Install the new sensor rotor on the side flange using Tools and a suitable press as shown. Make sure the sensor rotor is fully seated on the side
flange.
CAUTION:
Do not reuse the old sensor rotor.
2. Install the side flange on the final drive assembly. Refer to See: Transmission and Drivetrain/Differential Assembly/Seals and Gaskets/Service and
Repair/Rear Final Drive R200/Side Oil Seal (R200) or (R230).
CAUTION:
Do not reuse the side oil seal. The side oil seal must be replaced every time the side flange is removed from the final drive assembly.