Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
Cabin Temperature Sensor / Switch: Service and Repair
Intake Sensor
INTAKE SENSOR
Removal and Installation
REMOVAL
1. Remove the front kick plate. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Component.
2. Remove the lower dash side finisher. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Exploded View.
3. Remove the front pillar lower finisher. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Component.
4. Remove the assist grip handle.
5. Remove the front pillar upper finisher. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Component.
6. Remove the lower glove box. Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Exploded
View.
7. Remove the upper glove box (cluster lid E). Refer to See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Exploded View.
8. Disconnect the intake sensor electrical connector.
NOTE:
The intake sensor is located on the top of the front heater and cooling unit assembly next to the A/C evaporator cover.
9. Twist the intake sensor to remove the intake sensor from the front heater and cooling unit assembly.
INSTALLATION
Installation is in the reverse order of removal.