Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
Alignment: All Technical Service Bulletins
Steering/Suspension - Front End Alignment Cam Bolts
Classification: FA05-004D
Reference: NTB05-099D
Date: January 19, 2011
2005-2011 PATHFINDER, XTERRA, FRONTIER;
CAM BOLTS FOR FRONT WHEEL ALIGNMENT
The Applied Vehicles have been updated/amended. Please discard previous versions of this bulletin.
APPLIED VEHICLES:
2005 - 2011 Pathfinder (R51)
2005 - 2011 Xterra (N50)
2005 - 2011 Frontier (D40)
APPLIED DATE Vehicles built on or after August 15, 2005
IF YOU CONFIRM
An Applied Vehicle needs to have the front wheel alignment adjusted,
NOTE:
Applied Vehicles listed above come from the factory with non-adjustable bolts (Not Cam Bolts) for the lower link (lower control arm) mounting.
ACTIONS
1. Remove the original lower link mounting bolts, washers, and nuts - 2 per side.
^ Refer to section FSU in the Electronic Service Manual (ESM) for lower link mounting bolt locations.
2. Install new bolts (cam bolts), cam washers and new nuts.
^ New parts are listed in the Parts Information section of this bulletin.
NOTE:
Cam bolts are used to adjust caster and camber.
3. Perform front wheel alignment per the ESM.
PARTS INFORMATION