Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
Steering Angle Sensor: Service and Repair
Type 2 - Hill Descent Control/Hill Start Assist/VDC/TCS/ABS
STEERING ANGLE SENSOR
Removal and Installation
REMOVAL
1. Remove the spiral cable. Refer to See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair.
2. Remove the screws and remove the steering angle sensor from the spiral cable.
INSTALLATION
Installation is in the reverse order of removal.
-
Reset the neutral position of the steering angle sensor. Refer to See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Testing and Inspection/Programming and Relearning/Adjustment Of Steering Angle Sensor Neutral Position/Special Repair
Requirement/Type 2 - Hill Descent Control/Hill Start Assist/VDC/TCS/ABS.
CAUTION:
Any time the steering angle sensor is removed and installed or replaced, you must reset the neutral position of the steering angle sensor.
Refer to See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Programming and
Relearning/Adjustment Of Steering Angle Sensor Neutral Position/Special Repair Requirement/Type 2 - Hill Descent Control/Hill Start
Assist/VDC/TCS/ABS.