Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
-
On VQ40DE, install the bolts and tighten to specification in the order shown.
-
After installation, bleed the air from the hydraulic circuit thoroughly. Refer to See: Power Steering Bleeding/Service and Repair.
NOTE:
Belt tension is automatic and requires no adjustment.
POWER STEERING OIL PUMP BRACKET (VQ40DE)
Removal
1. Remove the power steering oil pump.
2. Remove the bolts and the power steering oil pump bracket.
Installation
1. Position the bracket and install the bracket to block bolts finger tight.
2. Tighten the bolts to specification in order as shown.
3. Install the power steering oil pump.
Disassembly and Assembly
POWER STEERING OIL PUMP
Disassembly and Assembly
VQ40DE ENGINE