Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
Steering Gear: Removal and Replacement
POWER STEERING GEAR AND LINKAGE
Removal and Installation
CAUTION:
Spiral cable may snap due to steering operation if the steering column is separated from the steering gear assembly. Therefore secure the
steering wheel to avoid turning.
REMOVAL
1. Set front wheels in the straight-ahead position.
2. Remove the front tires from the vehicle, using power tool.
3. Remove the undercover, using power tool.
4. On 4WD models, remove the front final drive, then support the drive shafts, using suitable wire. Refer to See: Transmission and
Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Front Final Drive R180A (R180A), (M205).
5. Remove the stabilizer bar brackets and reposition the stabilizer bar. Refer to See: Suspension/Stabilizer Bar/Service and Repair/Front Suspension.
6. Remove the cotter pins at the steering outer sockets.
CAUTION:
Do not reuse the cotter pins.
7. Loosen the outer socket nuts.
8. Remove the steering outer sockets from the steering knuckles, using Tool, then remove the nuts.
Tool number : HT72520000 (J-25730-A)
CAUTION:
-
Do not damage the outer socket boots.
-
Do not damage the outer socket threads. Thread the ball joint nut onto the end of the outer socket during removal.