Pathfinder 2WD V6-4.0L (VQ40DE) (2009)
5. Install A/T fluid temperature sensor 2 to bracket.
6. Install A/T fluid temperature sensor 2 (with bracket) to control valve with TCM. Tighten A/T fluid temperature sensor 2 bolt to the specified
torque. Refer to "Control Valve with TCM and A/T Fluid Temperature Sensor 2".
CAUTION:
Adjust bolt hole of bracket to bolt hole of control valve with TCM.
7. Install control valve with TCM in transmission case.
CAUTION:
-
Make sure that turbine revolution sensor is securely installed into turbine revolution sensor hole.
-
Hang down revolution sensor harness toward outside so as not to disturb installation of control valve with TCM.
-
Adjust A/T assembly harness connector of control valve with TCM to terminal hole of transmission case.
-
Assemble it so that manual valve cutout is engaged with manual plate projection.