Pathfinder 2WD V8-5.6L (VK56DE) (2008)
Removal and Installation
REMOVAL
1. Remove center console.
2. Remove yaw rate/side/decel G sensor nuts as shown.
^
The location of the sensor is the same for all models.
CAUTION:
^
Do not use power tools to remove or install yaw rate/side/ decel G sensor.
^
Do not drop or strike the yaw rate/side/decel G sensor.
3. Disconnect harness connector and remove the yaw rate/side/ decel G sensor.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: After performing the above work, calibrate the decel G sensor. Refer to "CALIBRATION OF DECEL G SENSOR: Special Repair
Requirement".