Pathfinder 4WD V6-3.3L (VG33E) (1996)
Engine Control Module: Pinout Values and Diagnostic Parameters
ECM Harness Connector
1. ECM is located behind the glove box. For this inspection:
-
remove the glove box bucket.
-
Remove lower finisher panel by reaching through the glove box and releasing the spring clips.
ECM Harness Protector
2. Remove ECM harness protector
Tester Probe
3. Perform all voltage measurements with the connectors connected. Extend tester probe as shown to perform tests easily.
-
Open harness securing clip to make testing easier.
-
Use extreme care not to touch 2 pins at one time.
-
Data is for comparison and may not be exact.