Pathfinder 4WD V6-3.3L (VG33E) (1996)
3. Crank engine for at least 2 seconds.
With Generic Scan Tool (GST)
1. Crank engine for at least 2 seconds.
2. Select "MODE 3" with GST.
Without Tools
1. Crank engine for at least 2 seconds.
2. Turn ignition switch "OFF", wait at least 5 seconds and then turn "ON".
3. Perform "Diagnostic Test Mode II" (Self-diagnostic results) with ECM.
Procedure for malfunction B and C
With CONSULT
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT.
3. Start engine and run it for at least 2 seconds at idle speed.
With Generic Scan Tool (GST)
1. Start engine and run it for at least 2 seconds at idle speed.
3. Select "MODE 3" with GST.
Without Tools
1. Start engine and run it for at least 2 seconds at idle speed.
2. Turn ignition switch "OFF", wait at least 5 seconds and then turn "ON".
3. Perform "Diagnostic Test Mode II" (Self-diagnostic results) with ECM.
COMPONENT INSPECTION
1. Start engine.
2. Check voltage between camshaft position sensor terminals (3), (4) and ground with AC range.
If NG, replace distributor assembly with camshaft position sensor.
Distributor Cap Signal Plate
3. Remove distributor cap. Visually check signal plate for damage or dust.