Pathfinder 4WD V6-3.3L (VG33E) (1996)
With CONSULT
1. Turn ignition switch "ON".
2. Select "MANU TRIG" and "HI SPEED" in "DATA MONITOR" mode with CONSULT.
3. Select "THRTL POS SEN" and "ABSOL TH/PS" in "DATA MONITOR" mode with CONSULT.
4. Press RECORD on CONSULT SCREEN at the same time accelerator pedal is depressed.
5. Print out the recorded data and check the following:
-
The voltage when accelerator pedal fully released is approximately 0.3 - 0.7V.
-
The voltage rise is linear in response to accelerator pedal depression.
-
The voltage when accelerator pedal fully depressed is approximately 4V.
Without Tools
1. Turn ignition switch "ON".
2. Check the voltage between ECM terminal (23) and (43) (ground) and check the following:
-
The voltage when accelerator pedal fully released is approximately 0.3 - 0.7V.
-
The voltage rise is linear in response to accelerator pedal depression.
-
The voltage when accelerator pedal fully depressed is approximately 4V.
COMPONENT INSPECTION
1. Disconnect throttle position sensor harness connector.