nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Accelerator Pedal|Specifications|Page 8405 > < Accelerator Pedal|Specifications|Page 8403
Page 3
background image

-

Release the two lock tabs, then pull the adjustable brake pedal cable to disconnect it from the adjustable accelerator pedal.

7. Remove the two upper and one lower accelerator pedal nuts.
8. Remove the adjustable accelerator pedal assembly.

CAUTION:

-

Do not disassemble the accelerator pedal assembly.

-

Do not remove the accelerator pedal position sensor from the accelerator pedal bracket.

-

Do not disassemble the accelerator pedal adjusting mechanism.

-

Avoid damage from dropping the accelerator pedal assembly during handling.

-

Keep the accelerator pedal assembly away from water.

REMOVAL FOR NON-ADJUSTABLE ACCELERATOR PEDAL

1. Disconnect the negative battery terminal.

2. Disconnect the accelerator position sensor electrical connector.

a. Pull the connector lock back to unlock the connector from the accelerator pedal position sensor as shown.
b. Pull up on the connector to disconnect it from the accelerator pedal position sensor as shown.

3. Remove the two upper and one lower accelerator pedal nuts.
4. Remove the accelerator pedal assembly.

CAUTION:

-

Do not disassemble the accelerator pedal assembly.

-

Do not remove the accelerator pedal position sensor from the accelerator pedal bracket.

-

Avoid damage from dropping the accelerator pedal assembly during handling.

-

Keep the accelerator pedal assembly away from water.

INSTALLATION

Installation is in the reverse order of removal.

INSPECTION AFTER INSTALLATION

-

Check that the accelerator pedal moves smoothly within the specified range.
Accelerator pedal - total pedal : 48 mm (1.89 in) applied stroke "A"

-

Check that the accelerator pedal smoothly returns to the original position.

-

Perform an electrical inspection of the accelerator pedal position sensor. Refer to "DTC P2138 APP SENSOR".  See: Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/P Code Charts/P2138

CAUTION:  When the harness connector of the accelerator pedal position sensor is disconnected, perform "Accelerator Pedal

Accelerator Pedal|Specifications|Page 8405 > < Accelerator Pedal|Specifications|Page 8403