Pathfinder 4WD V6-4.0L (VQ40DE) (2006)
2. Remove yaw rate/side/decel G sensor nuts as shown.
^
The location of the sensor is the same for all models.
CAUTION:
^
Do not use power tools to remove or install yaw rate/side/ decel G sensor.
^
Do not drop or strike the yaw rate/side/decel G sensor.
3. Disconnect harness connector and remove the yaw rate/side/decel G sensor.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: After performing the above work, calibrate the decel G sensor. Refer to BRC-128, "Calibration of Decel G Sensor". See:
Acceleration/Deceleration Sensor/Service and Repair/HDC/HSA/VDC/TCS/ABS/Calibration of Decel G Sensor